perich brothers (and sister): how to split wishbones, break a jack, make a tire swing...

Since the body is off the frame,
now is the perfect time to traditionally set up the rearend of the 40.

unsplit wishbone rear suspension

Early on I had tried to replicate an unsplit wishbone setup,
similar to using the front radius rod ball on the rear wishbones.
This setup works as it's on my pickup,
the problem is it is difficult to tune or align.
Now that there is a full floor on the body,
I've realized it is also easier to change right now.

rear unsplit wishbone balljoint suspension

Definitely a bummer to cut out all this old work out,
but that's what happens.

split wishbone kit

Speedway makes it too easy by selling a balljoint and weld bung kit.
Make sure you buy the little brackets with the 7 degree tapered hole,
this is really important unless you have the correct reamer.
All this is under $50.

oiling

There is a huge amount of measuring, positioning, remeasuring, jacking, thinking, cutting...
to get to the step where the threaded bungs can be welded in.
Once welded up,
I like to squirt some oil down the radius rods.
There are a couple small holes that hold the brake line brackets,
and it is amazing how rusty some of these are inside.

split wishbone mock up

Now it is time to make the template for the bracket mount.
To me it is easier and cheaper to build one from scratch using those tapered hole tabs
and some scrap steel.

full circle scrap

This chunk of scrap was used to press the top cowl piece.
Weird how that works.

input shaft angle

The most important part of setting up the rearend,
is matching the pinion angle to the transmission/engine.

pinion angle

Since the frame is jacked up at a random position,
the angle isn't important,
only that they are equal.

clamped

The only issue at this point is the correct angle of the rear end,
not the alignment.
Good time to have a stash of clamps and wood blocks.

aligning wishbones

The plate is mounted,
so now the tie rod brackets can be attached.
All that measuring that was done before the first cut now needs to be remeasured to perfection,
or else the car will crab down the road sideways.

Make sure to leave 5 or 6 threads out of the jam nut for tuning purposes.
Also make sure you take off the rubber tie rod covers when tacking,
and take the tie rods out when welding!

welded up

Let's let it cool off.
Perfect time for a break.
******************************************************

sausage - riddles are abound tonight

******************************************************

hot rod frame

With the suspension all assembled,
we did an extended frame bounce to make sure it wasn't bound up anywhere.
No problem.
Even forgot to take a picture of the finished assembly!

in position

With no time to waste,
the kids and I rolled the frame back underneath the levitating body.

broken jack

Perfect time to break the jack!

1940 ford coupe chopped and channeled

There was a concern that the body mount holes wouldn't line up.
Nope this thing is stiff as a,
well let's just say everything fit perfect.

working or sleeping?

And here's a sneak peak of the rarely seen passenger side.
always been stuffed over by the wall.
It was a long day,
by this photo it was after 9pm.
Is that Jake sleeping or working?